What Are The Maintenance Methods of Reflow Oven?

SMT Reflow Oven

Stop reflow oven and reduce the temperature at room temperature (20~30 degrees) before maintenance.

1. Clean the exhaust pipe: clean the oil in the exhaust pipe with cleaning agent soaked in a rag.

2. Clean the dust of the drive sprocket: clean the dust of the drive sprocket with a cloth and alcohol, and then rejoin the lubricating oil. Clean the inlet and outlet of reflow soldering machine, check whether the inlet and outlet are stained with oil and dust, and wipe clean with a rag.

3. The vacuum cleaner will absorb the flux and other dirt in the furnace.

4. Wipe clean the flux and other dirt absorbed by the vacuum cleaner with a rag or dust paper dipped in the furnace cleaner.

5. Adjust the lifting switch of the furnace to OPEN the furnace rise, observe whether the outlet and part of the furnace are covered with flux and other dirty things, with a shovel to shovel the loot, and then clean up the furnace cleaner.

6. Check the upper and lower Blower hot air motor. No dirt, foreign body. If there is dirt or foreign body, remove it with CP-02 to clean the dirt and then remove rust with WD-40.

7. Check the transmission chain: check whether the chain is deformed and consistent with the gear, and whether the hole between the chain and the chain is blocked by foreign matter. If available, iron brush will be removed.

8. Check the filter screen in the inlet and outlet exhaust box.

1) Remove the back seal plate of the inlet and outlet pumping bellows and take out the filter screen.

2) Put the filter into the cleaning solvent and clean it with a steel brush.

3) After cleaning, the solvent on the surface of the filter screen is volatilized clean, and the filter screen is inserted into the exhaust box and the exhaust sealing plate is installed.

9. Check the lubrication of SMT reflow oven regularly

1) Oil the bearings of the nose and the width adjusting chain.

2) Synchronous chain, tensioning wheel and bearing oiling.

3) Oiling the bearing of the nose transport chain over wheel.

4) Oil the head screw and the drive shaft.