In the process of operation and use of the SMT machine, there will be many mistakes. This not only reduces our production efficiency, but also affects the whole production process. To guard against this, here is a list of common mistakes. We should correctly avoid these failures, so that our machine can be better operation.
Wrong operation 1: when we are setting the material position, we need to accurately calibrate the position, because the incorrect position is one of the common faults of many machines that appear to throw material and stick crooked. If there is a problem with the position, we need to correct it in time and check it each time before using the PNP machine.
Wrong operation 2: Can not be used on the way to replace the material operation, which will not only lead to the failure of the SMT, but also threaten our life safety. If we want to change the material in a hurry, we may wish to brake the machine in an emergency way, so as to ensure personal safety.
Wrong operation 3: When pick and place machine is running, we should not put the body deep into it. If you need to observe the operation, you need to close the safety window, and then observe outside the window. If there is an accident, we need to close it urgently.
Wrong operation 4: We like to check the effect of placing when we place the SMT machine, which is a good operation. But many bad manufacturers find fault materials after inspection, and carry out secondary processing, which is a great damage to the material.
Here are four of mistakes for your reference.
Post time: Mar-04-2021