We may encounter in the process of using pick and place machine can not operate normally, the situation we start not to worry, check the power supply connection, because it is possible that your power plug is not plugged in. of course, there may be voltage problems, the biggest problem is the equipment internal problems. This time we must contact the relevant personnel to troubleshoot and repair. NeoDen to share the use of common problems and handling methods for pick and place machine.
1. The chip machine in use will appear in the case of heat, we will worry about this situation will damage the equipment, in fact, the general heat is the equipment overload work caused by. If you turn on the machine on the heat of the situation, then we must check the internal problems of the equipment, to be repaired in a timely manner.
2. in order to ensure that the machine can extend its service life, we should work in the usual pick and place machine to carry out good maintenance, regular cleaning of the machine, because some parts of the machine dirty, may also affect the use of the SMT machine.
3. in some of the more extreme weather, we had better not use SMT machine, this is indeed a security risk, may also bring negative impact on the work, so this point we need to pay special attention.
4. at the same time we use the machine, some of the relevant practical specifications are also need to have a good grasp of, understand clearly some of the relevant operational matters, especially where the need to pay attention to.
Post time: Jan-18-2023