SMT suction Nozzle is the main component of SMT pick and place machine, daily maintenance and cleaning of it is very important.
Now Neoden SMT machine factory will tell you how to maintain the suction nozzle of the pick and place machine, please see the following:
1. Wipe the surface of SMT nozzle with dust-free cloth.
2. Small diameter suction nozzle can be used with fine steel wire, and then air gun blowing.
3. The surface of the nozzle can not be soaked with corrosive solution such as alcohol, otherwise the surface will fall off.
4. Holder with cotton swab rub cavity, can not poke bad filter.
5. Holder claws regularly add special grease.
6. According to the production of the best regular maintenance, usually do other maintenance.
Check
1. The terminal of the suction nozzle of the SMT machine has no deformation or partial wear due to impact, and confirm that there is no foreign body blockage inside the suction nozzle.
2. Press the suction nozzle with your hand, whether it feels tight
Post time: May-27-2021