Anyone who uses a SMT machine knows that the pressure is a very important part of the machine. In using a SMT machine, not only do you need voltage, but you also need pressure to help use it. Sometimes we will find that pick and place machine is not getting enough pressure. What do we do if there is an alarm due to insufficient air pressure?
When our machine is running, the air pressure is limited by the machine, so when the air pressure is below or above the target value, the SMT machine will sound an alarm and the relevant parts of the machine will also fail due to the following reasons. The causes are as follows.
1. Abnormal paper supply: the paper supply cassette fails to supply paper properly. If the suction nozzle is working properly at this time, the nozzle may be damaged.
2. Abnormal stop: this will seriously affect the visual positioning of the mounter and may cause the mounter head to contact the PCB board.
3. Abnormal head placement: the movement of the placed head is affected, resulting in an inability to expand and contract in the usual way.
We know the dangers of too low air pressure and we must address it. Usually, low air pressure is caused by distortion, damage, clogged nozzles, insufficient air pressure, leaks and premature absorption, resulting in the nozzle not absorbing or absorbing the material properly. If the material is not correct, the nozzle needs to be replaced frequently and maintained frequently for smooth placement operations on the mounter.
In summary is the solution to the situation of insufficient air pressure in the pick and place machine if encountered, I hope it will be helpful to you.
Features of NeoDen10 SMT machine
1. Equips double mark camera + double side high precision flying camera ensure high speed and accuracy, real speed up to 13,000 CPH. Using the real-time calculation algorithm without virtual parameters for speed counting.
2. Front and rear with 2 fourth generation high speed flying camera recognition systems, US ON sensors, 28mm industrial lens, for flying shots and high accuracy recognition.
3. Mouting height Up to 16mm, precision design and stable performance.
Support 1.5M LED light bar placement (optional configuration).
Post time: Feb-07-2023