Common fault analysis and solution of SMT Feeder

During SMT production, SMT machine often encounter some problems, which affect the efficiency and productivity of the patch. In the patch production, SMT Feeder is the most common part with problems.

The following to help you analyze the common failures and solutions of the SMT machine, We hope to be helpful to you.

1.Don’t pick the material

Solution: check whether the specified Feeder is correct, wrong, then need to adjust; After the program set the material taking mode, check the material taking position of X/Y axis;

2.Failure of the SMT nozzle in Feeder and Feeder small box

Solution: Check to see if you are using the correct box. If you are using a Stick, you need to do track correction.

3.Large deviation of material level leads to deviation or leakage

Solution: manual correction of the corresponding Feeder fetching coordinates

4.The material belt and plate are stuck

Solution: Feeder abnormal, the corresponding Feeder out to check the export channel can be cleaned

5.Special material discarding

Solution: find out the corresponding Feeder, the material convex parts of the flattening;

The common problems of the Feeder is the above. In the actual SMT production, the actual analysis of the problems encountered can guarantee the normal operation and the productivity efficiency of the patch.